Line Swivel 0505/00505A Series

+ Click on a photo below to enlarge.

No photos found.

Line Swivels

LINE SWIVEL - 0505/00505A Series:

 

DCD Line Swivels are typically constructed with a thrust bearing for tensile load and a radial bearing for bending load. They combine a high safe working load with a compact design. All sizes incorporate and oil sealand are manufactured from high strength Stainless Steel. 

DCD has recently added Locking Line Swivels to their product line. These are typically constructed wih a Bronzethrust bearing for tensile load and a radial bearing for bending load. They combine a high safe working load with a compact design. Due to rhe use of a Bronze bearing in place of a roller bearing, rotation will only continue up to a certain load, much less than the Safe Working Load. Once past this point, then rotation will only occuer when pulling tension is relieved.

Sizes 00505-020 and large are supplied with a grease point for lubrication. This is particularly useful in overhead applications where high speed rotation is possible.

All sizes of both types are pull tested to verify the 3:1 safety factor and all (swivelling) sizes are fully capable of rotation at full working load. 

Test certificates are available upon request.

Sizes 00505-025 and larger are supplied with hexagon Clevis Pins. Smaller sizes have slotted Clevis Pins.

For Clevis details and pin replacement see catalogue sheet series 00000 (page 2). Under no circumstance should alternate Clevis Pins be used.

Note: Line Swivels are not designed to run around bull wheels and severe damage or injury may be incurred if this is done.

 

 BREAK AWAY LINE SWIVELS

MIN-E-MAX BREAKAWAY CONNECTOR - 00530 SERIES:

The purpose of this product is to protect the utility being installed from overload. Typically, they would be used during the installation of Fiber Optic Cable or very small gas ducting where the connector can be pre-set to breakaway at a pre-determined load thus protecting the fibers or the duct.

The patented system for changing the breakaway pins allows the same connector or swivel to be used with a variety of different breakaway pins. Changing a pin takes just seconds.

* See chart below for details of Breakaway Pin Kits.

 

BREAKAWAY SWIVEL - 00550 SERIES:

The purpose of this product is identical to the above connector except that it incorporates a swivel.

These products are availabe in 3 different sizes each with a different capacity range.

See chart below for details of Breakaway Pin Kits.

 

BREAKAWAY PIN KITS FOR BOTH - 00530/00550 SERIES PRODUCTS:

Breakaway Pin Kits for Group A & B are supplied in bags of 10 pins and 10 retaining clips. For Group C pins are supplied in bags of 5 pieces. Breakaway values are guaranteed to +/- 10%.